For some, the prospect of change in speaker is extremely difficult because you must remove the door panels for access to speakers hidden within its walls. "I'm not complicated, it seems, if you know the proper techniques.
The first thing to do is find the screws holding the panel in place. These are generally found in or under the armrest piece, in the opener stationary, or at the bottom of the door. as much as you can find a run taken.
With the screws removed, you will need to carefully explore the doors off the door car. Start at the bottom closest to the speaker. Carefully pull the panel does not open until dissolved. There are usually several clips holding it in place. Work around the bottom of the door panel clips popping out. Be careful not to break, because you need to reinstall. Continue around the outside of the panel and remove as many videos as you can. If you have power windows, doors, etc., remove the control panel from the door panel. This is usually lower efficiency and can be tucked carefully around the outside. Look for small notches that may give the position of the clip. If you have a Windows computer, you push the door panel in the door window handle, and look for the snap ring clip holding it in place. With a thin screwdriver, pop the clip loose, taking special note of where it goes, because you modifications have set the piece in place. Once removed, you should have enough space to reach the loudspeaker. Otherwise, you can feel completely remove the door panel by sliding up and out of the window area. You may be trapped 'door station stopped. These can be a little 'difficult because some will slide horizontally, screw or pop out. Check the screws, and if not found, try to go straight inside. If this fails, try to open outwards. They will be connected to pull the handle bar to be in the proper position for the door panel must be removed. If a triangular piece of trim at the top of the door panel will have to be removed. It also clips in place and can be removed. This should allow the door panel to the extension, provided that you have disconnected the control panels electrical wires.
You should now be in full view of the speaker leads. it can be removed by removing four screws holding it in place. You can car modifications also find the connectors for the speakers do not work for the aftermarket, so you need to clip the wires and attach the hose supplied with the speakers. Pay attention to positive and negative here. If you're not sure what's what, there are some ways to check. Look at the speaker terminals supplied. You may have "and" - "sign designating positive and negative. If I told you that you can find color codes for speaker installdr.com or try test battery. Take a good battery and place one of the factory speaker wires (attached to speaker) in the positive and negative battery. If the speaker pushes out, the correct polarity, as you and connect the wires accordingly. If the prints, the polarity reversed, so reverse the battery and try again. If printed out, the speaker wire polarity.
Install the speaker in the door, replace 4 screws and securing in place, and then the door panel. Make sure the image is in place and align the clip just before use pressure to re-connect. One of them bursts. Finish screwing the door in position, then connect the Control Panel / window crank, and congratulations, you!
The Secret To Door Panels And Door Speakers
Langganan:
Posting Komentar (Atom)
0 komentar:
Posting Komentar